Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have 2 switch (3750) need to set redundancy, so I set up as below:SWITCH 1interface GigabitEthernet1/0/2description "To EP LAN"switchport trunk encapsulation dot1qswitchport trunk allowed vlan 18switchport mode trunkinterface Vlan18description "A...
HII have a switch is 3750 24T-S which is IP Base modelNow I need use BGP which need IP Servce imageCan I download a IP Service image and install on my switch to make it workOr any alternative method to change it to IP ServiceThanksCalvin
Hi When I config BGP on my 3750X Switch, it show error as below:protocol not in this imageAny idea about this, should I need to upgrade the IOS or Where I can found a supported image (support BGP)Thanks Very MuchCalvin
Hi All,I just bought 2 Cisco3750 X Switches, After I open the box, there are too many numbers lables on the switch.1. Which number is for product registration ?2. Can anyone give me the link for product registration ?BTW, can explain to me what is PA...
