Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I go to the http://<unity-server-ip>/web/sa web page I get a "the requested resource is in use" This is on a unity server that is running on win2k3. This all started when the winsocks got corrupt. I had to manually rebuild the TCP/IP conne...
I have 2 ASA 5510's in a failover bundle. I have a weird issue right now, where a site (https) is apparently getting blocked behind the firewall. If I browse to the site, it just spins, then says the page could not be displayed. I can ping the IP ...
I have an ASA 5505 that is resetting to factory defaults every time it reboots. I write to memory every time, but as soon as the power is disconnected, or I reload it, it boots back up as "ciscoasa" with the factory defaults. Does anyone know what ...
I need to build an H.323 gateway with 8 FXO ports out of either a 2811 or a 2821 router. I'm having a hard time finding out exactly which combination of NM card(s), PVDM's, and VIC cards I need.I was thinking if I used a 2811 with an NM-HD-2V, then ...
I'm not new to Cisco routing and switching by any means, but I seem to be missing a basic routing issue somewhere. It looks like a rookie mistake, probably. I could use a second set of eyes on it. Basically, I have a remote switch that I cannot pi...
Well, we figured this out. It actually wasn't the firewall. It was DNS resolution. This particular site's DNS was all messed up. When I was on the DMZ, I changed to another DNS server, which hadn't updated yet. External DNS tests were all return...
Yes, my core ASA 5510 is running 8.2(1), and I have a few different versions on my remote devices. I think my most up-to-date ASA 5505 is running 8.2(4).
No, unfortunately not. I've been struggling with this for years, and haven't found a good way to maximize the speeds on my tunnels. I'm sure things would go faster if I was allowing split-tunneling, but our compliance policies do not allow that. I...
Thanks for your help. It would have taken me a long time before I looked at the configure register. Mine was set to 0x41. So I changed it, using:config-register 0x1After that, I reloaded the ASA, and it saved the config like normal. Thanks again ...
