Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 segment vlan 100 & vlan 101 at the branch office and design to put the Flexconnect AP native vlan and user vlan together which is vlan 100 and vlan 101 for Production vlan. The best practice is separate the AP management vlan separately but ...
Hi, I will like to know if possible to migrate the configuration from Cisco WLC 9800 CL virtual version to WLC 9800-40 Physical unit with just download the CL version configuration and upload to the 9800-40 physical unit? Thanks
Hi Expert, I'm using WLC 9800 CL and i recently downgrade the firmware from 17.5.1 to 17.3.3 due to some voice traffic keep having call quality issue, after i downgrade the firmware to 17.3.3 solve my problem then i found after few days(not sure exac...
Hi, I'm using wlc 9800 cl version 17.5 with SSO HA RMI+RP and one of my vWLC went to recovery mode, and i found the interfaces 1 & 2 uncheck in the checbox(which i dunno why could be like this) at ESXi network adaptor and cause the problem. I did re-...
Hi Thanks your answer. May you please convenience to share me the document to stated this so i can further study on it? Appreciate.(Yes it will work without any problem now.At the early stages of IOS-XE on C9800 there was an issue where AP3700 were u...
HiOne is vlan 100 for native AP management Vlan and User traffic, vlan 101 is production traffic. My question can i put AP native vlan and user traffic under same vlan for flexconnect mode. Thanks
