Hi,i am running IOS 15.2(4)M2 on a 2901but i cannot put command ipv6 dhcp relay source-interface although the command is on the config guide. anyone know why or have the same problem?thank you
Hi,i have a problem with N5K keepalive link over mgmt 0the mgmt 0 port is connected to a N2K on a N7K.the port on N2K is access vlan. and is put to a Network Management VLAN.but i still cannot ping each other from the management port and the keepaliv...
Hi,anyone know if "vpc-orphan-port suspend" works if i put on N2k interface. not the fex link.example i have fex 101and i put on eth 101/1/10will it suspend the port on N2K connected to secondary N5K when peer link is down?regards
Hi,if i use OTV unicast mode.and both primary and secondary adjacency server is down, what happen to existing OTV network?will the existing OTV connection still running on other edge device ?thanks,ivan
Hi hubert,i test putting vpc orphan-port suspend first then put the channel-group config.it works as expected.i am not sure if this is a bug or not supported config.have you found a solution?
