Hello, Experts!How can I set a policy of load-balancing etherchannel for only one interface Po1? This policy be applied to this interface only, and NOT applied to other interfaces. Device:C2960GIOS:c2960-lanbasek9-mz.122-58.SE2.bin
Hi, experts.I have a necessity to adjust static NAT on Cisco 2621xm.i do:1. First Config:interface FastEthernet0/0 no ip address speed auto full-duplex ! interface FastEthernet0/0.9 encapsulation dot1Q 9 ip address <public ip> 255.255.255.240...
To enable routing on the switch Layer 3, you must enable ip routing in the global configuration mode.C3750-1(config)#ip routingC3750-1(config)#sh run... !switch 1 provision ws-c3750x-48system mtu routing 1500ip routing!...
