Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I'd like to check the limitation of pppoe sessions for RSP-440-SE, can't go over 1582 sessions.HW setup: 9006 ASR ( RSP-440-SE+MOD80-TR+2XMPA 4x10G) , subscribers terminated through bundle interface on LC (RSP subscribers).As per search, the RSP s...
Hello A new ASR 9901 and trying to activate ospf under global or interface mode, the ospf commands are not showing !! RP/0/RSP0/CPU0:AGG-01(config)#router ?bgp BGP configuration subcommandshsrp HSRP configuration subcommandslisp LISP configuration su...
Hello We are deploying a new core 9696 with access sw inside DC, want to deploy:-Integrate new switches with ISE-Use 802.1X for wired/wireless users What are the steps, do we need to config AAA on the switches also or ISE auth is enough. Any templat...
Hello
I want to enable SDM video template on ASR 903 RSP3 , it's not showing as below :
sdm prefer ?default default template ipv4 ipv4 templateipv6 ipv6 template
ASR details:
Cisco IOS XE Software, Version 03.18.01.S
#show license detail Index: 1...
Hi SamiI understand mod80 should be SE type not TR. The limit of 32k per/LC is 100% perfect for me if it's work.For bundle it's just has 1 member int. The problem the LC not passing 1580 subscriber which is so far from the NPu HW limit.I think to agg...
Thanks Marvin for your advice.
the expected band for the main site is 200Mbps & branches 25 Mbps each with direct Internet access.
I'm thinking to use ISR 890 for the branches without fw and use ASR1002-5G-VPN/K9 for the main site do this work fine ?
