Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Colleagues:
I need to know which exam I need to pass to get my CCNP Security Certification. I’m aware that the exams have changed, but I remember that the old exams count towards to certification. So far I have taken and passed the following ex...
Hi guys:I would like to obtain a trial version of the ACS 5.4 for educational purposes (certification LAB). I know that it is possible to download the ISO file from www.cisco.com, but when a try to download the file with my cisco CCO a get a mess...
Hi cisco Guys:I hope you can help me with this situation. We have a switch metro ME-3400 that works with -48 V DC, but unfortunately we have lost a very important part of the device: The DC terminal block. In case you are wondering with part is this,...
Hi cisco Guys:I'm configuring Control Plane Police in a Catalyst 6509. This equipment is using IS-IS like its IGP routing protocol, and iBGP. In order to make CoPP work Im classifying the traffic entering the control plane like CRITICAL, IMPORTANT, N...
Hey guys:My boss put my in charge of the implementation of an SNMP program that draw staticts of diferents nodes of the network. The program in cuestion is called CACTI, maybe you've heard somenting about this program; the program is currently workin...
Hi Giuseppe:thank you so much for the answer. I find it very useful. Correct me if Im wrong. 1. First I have to classify the critical TCP/IP traffic in the control plane (traffic like iBGP). I will do that with an access-list name CRITICAL-ACL (for ...
HIFirst at all you should be sure that the networks that you are announcing in R5 are present in its rounting table. You can do this issuing the command "show ip route" and you should be able to see the two networks 192.168.0.80/28 and 192.168.0.96/2...
Hi:In my opinion, it is very dificult to find out why the switch doesnt flood the traffic when it doesn't have the destination MAC Address in its CAM table. But you could do a little trick, you could configure the MAC address with the follwing comman...
HiAccording with my experience it is always the best practice in a trunk between 2 switches set the duplex and speed manually to avoid problems with the automatic negotation. That's why I'm setting the speed and duplex in all the ports at both ends o...
Hi Fabio:The first thing you must understand about peer-group is that they are a form to group a set of neighbors that have the same caracteristics applied. The peer-groups are local to the routers and you can declare diferents peer-groups in diferen...
