About p.danielsen

p.danielsen · 11-17-2008

Hi,Iam trying to consolidat a number of DMVPN HUBs on an VRF Aware HUB, I have some difficulties getting it to work, HUB is a 7200VXR - Spokes are 2841All configuration examples I can find are with HUB and Spoke running VRF-Lite, and I need to figure...

p.danielsen · 11-24-2007

Question everyone on a strange problem,I just setup up a configuration running MPLS aware IPSec VPN using an SPA-IPSEC-2G module, If I from the internal interface, try to ping the remote end, of the VPN tunnel, there is no problem, then I add a route...

p.danielsen · 03-21-2007

Hi,Anyone seen this error on a WISM modul befor, ----------------snip----------------Message Keepalive messages are lost between Master and Controller'172.31.228.8'. Help Keepalive messages are lost between Controller '172.31.228.8'and Master.Please ...

p.danielsen · 03-08-2007

Hi everyone, I got a strange problem, on my FWSM, when i use the command wr mem i get a error, any one seen this befor ??ipmsap/act# wr memBuilding configuration...Cryptochecksum: xxx%Error copying flash:/startup-config (Cannot overwrite image (asdm)...

p.danielsen · 02-02-2007

Hi,Any one tried to configure a PIX firewall to proxy DHCP request through.I have a Central DHCP Server, and I want to use it for our clients placed on a other network, the only connection between the to networks a trough a PIX firewall.Illustrated....

p.danielsen · 03-21-2007

Hi Ankur,sh run | in wismwism service-vlan 9shows the same on both routers,RegardsPeter

p.danielsen · 03-08-2007

Yes the firewall is one part of failover setup, but it is the primary in the failover,the error was first seen after a password recovery attemt.cheersPeter

p.danielsen · 02-03-2007

Hi Raj,My plan was to use ip-helper on all client interfaces, But ...So the real question is, has anyone tryed the senario, when Client networks are placed on on side of a PIX Firewall, and servers are placed on anoter side,There is no servers/client...

p.danielsen · 01-30-2007

Hi Bala,try looking at this configuration, it uses access-lists insted of a prefix-list, but it works ..ip vrf ES rd 12345:10040 export map ES route-target export 12345:10040 route-target import 12345:10040!route-map ES permit 10 match ip address 20 ...

p.danielsen · 12-27-2006

Do you know if there is a linitation in the router ospf 1 vrf CUST1/Peter

Member Since	‎05-08-2001 12:29 AM
Date Last Visited	‎06-11-2024 01:03 AM
Posts	40

User Statistics

User Activity

DMVPN - HUB VRF Aware - Spokes no VRFs

MPLS Aware IPSec VPN using SPA-IPSEC-2G

WISM Error : Keepalive messeges are lost .....

Error when using wr mem

DHCP passing through PIX (FWSM)

Re: WISM Error : Keepalive messeges are lost .....

Re: Error when using wr mem

Re: DHCP passing through PIX (FWSM)

Re: export map on a vrf

Re: OSFP - VRF-Lite - Question