Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, reading the below link they recommend to manually configure the Mobility mac Ensure that you configure the mobility MAC address using the wireless mobility mac-address command for HighAvailability to work. Which mac address is this? is it the on...
Hi, i have the following scenario, R1 timer for Active route was changed to 1 minutes, all other routers are running the default 3 minutes. There is an ACL on R2 dropping all EIGRP packets from R3 so no replies will be sent to R1 from R2 because it w...
After reading ccie v5 official certification guide i realized that the Feasible distance is an historical value and not a "current" value. But i am trying to understand what is the benefit of keeping this historical value and not update this value wi...
My understanding is that it will send the SIA queries at half the configured active time (3 minuted by default) so it will send queries at 90 seconds. Now that i configured the timer at 1 minutes it is actually sending the SIA queries at 30 seconds b...
Thank you so much for taking time to answer my question I really appreciate that, by the way your example was awesome and it definitely helped me to better understand the point of keeping an historical value on the topology table.
Thanks for your prompt answer. So, i am using a really similar example to the one on the book on my LAB, i also turned off split horizon on R4 interface (ethernet0/0.14) So here is R1 topology table P 11.234.0.0/24, 1 successors, FD is 2560, serno 9 ...
