Hi   I have a C4507 on which I did a write erase followed by a redundancy reload shelf. I went about configuring however, I forgot to enter username and set logging local on console and had to do reset.    I pulled out the secondary and went about booting the switch from where in i have been in a continuous rommon mode. Once I issue boot bootflash: I would then be in the IOS. I have to do that on both the supervisor engines. Is there any way I can get this to function properly.    Directory of bootflash:/ 2 -rwx 18090440 Aug 20 2013 09:11:39 +00:00 cat4500-ipbasek9-mz.150-2.SG7.bin 59244544 bytes total (28751044 bytes free) Chassis Type : WS-C4507R Power consumed by backplane : 40 Watts Mod Ports Card Type Model Serial No. ---+-----+--------------------------------------+------------------+----------- 1 2 Supervisor V 1000BaseX (GBIC) WS-X4516 2 2 Supervisor V 1000BaseX (GBIC) WS-X4516 3 48 10/100/1000BaseT (RJ45) WS-X4548-GB-RJ45 4 6 SFP, 10/100/1000BaseT (RJ45)V, Cisco/I WS-X4506-GB-T 5 6 SFP, 10/100/1000BaseT (RJ45)V, Cisco/I WS-X4506-GB-T 6 6 SFP, 10/100/1000BaseT (RJ45)V, Cisco/I WS-X4506-GB-T 7 6 SFP, 10/100/1000BaseT (RJ45)V, Cisco/I WS-X4506-GB-T Mod Redundancy role Operating mode Redundancy status ----+-------------------+-------------------+---------------------------------- 1 Active Supervisor SSO Active 2 Standby Supervisor SSO Standby hot System Failures: ---------------- Power Supply: bad/off (see 'show power') Redundant System Information : ------------------------------ Available system uptime = 6 minutes Switchovers system experienced = 0 Standby failures = 0 Last switchover reason = none Hardware Mode = Duplex Configured Redundancy Mode = Stateful Switchover Operating Redundancy Mode = Stateful Switchover Maintenance Mode = Disabled Communications = Up Current Processor Information : ------------------------------- Active Location = slot 1 Current Software state = ACTIVE Uptime in current state = 5 minutes Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 15.0(2)SG7, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2013 by Cisco Systems, Inc. Compiled Wed 01-May-13 17:37 by prod_rel_team Configuration register = 0x2102 Peer Processor Information : ---------------------------- Standby Location = slot 2 Current Software state = STANDBY HOT Uptime in current state = 4 minutes Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 15.0(2)SG7, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2013 by Cisco Systems, Inc. Compiled Wed 01-May-13 17:37 by prod_r BOOT = Configuration register = 0x2102 BOOT variable does not exist CONFIG_FILE variable does not exist BOOTLDR variable does not exist Configuration register is 0x2102 Standby BOOT variable = Standby CONFIG_FILE variable does not exist Standby BOOTLDR variable does not exist Standby Configuration register is 0x2102 ... View more