cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1622
Views
10
Helpful
13
Replies
Jobin Varghese
Beginner

Configuring WLC

Hi

I am totally new to wireless controllers. I have configured access points, but now the organization is shifting to WLC and I have no idea as to properly configuring it. The diagram shows how the setup would pan out. I have added few screens of how i have managed to configure it so far.

  • How is dual-band configuration achieved ?  
  • Should network routes be added ?
  • Can the controller be a secondary DHCP server to a windows Primary DHCP server ?
  • Am I doing it correct ? 
13 REPLIES 13
Scott Fella
Hall of Fame Guru

Hard to say if your configuration is right as that is a small sample you provided. Dual band you don't have to worry about since that is typically with the 3x02's with modules. You don't want to use the dhcp in the controller at all in your situation since you have a windows server. Might as well bring up a secondary windows dhcp server. Just make sure the service port is not connected to the network.  Network routes on the controller is not used.  Other than that, the other screenshots look okay.

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***

Just make sure the service port is not connected to the network.

Could you elaborate on this point.

Jobin Varghese
Beginner

I tired to upgrade the controller and I am not able to boot into the upgraded image. Anything I do, it still boots in the old image.

Did you reboot the controller?  The default boot shows the new image, so it should boot into that image.

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***

Did reboot a couple of times. I sense something wrong, every time I go to the reboot menu it shows me save and reboot option. When I does reboot, I loose connectivity and it comes back up but GUI still shows the old image. 

Any command I can give in CLI to boot into this image. 

Try a different code and also check the MD5 hash on the file. 

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***

Tried another two, but surprisingly the 8.0.140.0 worked but 8.2.141.0 is still show similar to the 8.3.102.0.

Scott Fella