Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an 887VAW. Only 1 interface of the fastethernet ports was connected. Up till now I just need the 1 VLAN (VLAN10), so it was configured as an access port. However needs change.
So I configured fastethernet0 with
interface FastEthernet0 switc...
Anyone know how to interpret the stats correcty for the 887VA-W for the VDSL (Gathered via SNMP from the VDSL2-LINE-MIB?My 887VA-W gives me back obvious stuff. Like BitAlloc (Easy to parse, numbers seem to work out), but the SNR is a bit strange. I g...
I have my AP now running... Mostly... And associated clients now get ips from the router dhcp server, But although the docs indicate that you should be able to contact the ap via the BVI ip and use that to run the web intface, i cant get any response...
Hi.I now know that in order to have an ssid visible (broadcast) you need to set it as guest-mode in the dot11 config for the ssid. But how do i broadcast more than one ssid? When i try the AP disables the second and subsequent ssid and says only 1 ss...
I have an issue. I've got a brand new C887VA-W-E-K9 that is up and running on a BT VDSL connection. That side of it is fine... But the integrated AP module on it keeps reloading... I can be on the AP console reading the config via 'sh run' and sudden...
I connected in via the console, and I did some more testing...
The issue only seems to appear on the ethernet interfaces. The internal switch connect to the embedded AP still works fine with all configured VLANs (And that's in mode trunk already)
Th...
fa0 is the actual connection to the network. It's currently an access port with VLAN10. The original intent was to change it to a trunk port with VLAN10 as the native and the extra VLANs trunked.
However changing that from access to trunk resulted ...
VLAN 10 isn't supposed to be ON the trunk...
On fa0 it's the native (Untagged VLAN). Whether it's an access port or a trunk port.
On fa1 it doesn't exist at all.
My issue is not that VLAN 10 doesn't appear TRUNKED on fa0... It's that when I set th...
BV1 isnt used. The management is on vlan10. I have tried to keep the vlan id the same as the bridge group to make things more straight forward.It is working now. I asked our ccie at work. He clarified a few tings and confirmed some assumptions id bee...
