Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
A customer's attendant console cannot initiate calls though the attached deskphone can make calls.
The following error message is always returned when calls are initiated from the console:
unable to make call.The following error was return...
A customer has recently acquired a cisco 2960 switch which I am to set up.After running the express set up and putting the ip information, the switch was put on the network but the ip address is not pingable and we cannot telnet into it.I also connec...
I have deployed a cisco 2504 controller on a production network.We intend to change the preshared on an existing WLAN key but we couldn't see this option in the GUI. Can anyone please show how to do this.Either GUI or CLI.(GUI preferable) Thanks in ...
I am to deploy 2504 wlc and 6 pieces of CAP2602E.(external antenna AIR-ANT2524DB-R which I use has been verified to be compatible with AP)The configs has been done and APs can communicate with the controller, and there is wireless signal but the p...
I am fairly new to this forum, pretty new to cisco but I know I will get good help from here.I have 2 pieces of ASA5505 and I want a site to site VPN for my network of two locations.Site A(HQ) and SiteB(branch)The purpose is to access a server with l...
Thanks Martin,After express setup, from the switch console, we could see it booting succesful and checking interfaces succesfully but it does not bring the user mode(sw>) where we can issue commands.We assign 192.168.0.1 to switch during express set ...
Thanks for your response Rasika. After using the commands, I hope the authentication method will still remain only PSK just like before.Since this is production network.
Hi guys.I have the following questions regarding this same project:1. From wireless clients, pings to default gateway returns in 2ms and 5ms.Pings from PCs directly connected to LAN by cable returns in constantly at 1ms.How can I modify wireless so...
Thank you Sandeep and Leo. I could get 80meters coverage with each AP in the open office.For people who might be in similar situation in future, here are the things I did:1. I discovered there are so many Dlink, cisco autonomuos APs currently in use ...
