Hello, I have a few Cisco unmanaged switches (SG90D-08) and they have a problem "blocking network signal from another switches" when using the ethernet cable has 6 wires (3 pairs) for network and 2 wires (1 pair) for phone line.For Example :Juniper /...
Hello,
I have a problem on Cisco Asa. Here are my config:
object network PARTNER-NETOBJ subnet 10.175.0.0 255.255.0.0nat (PARTNER,outside) dynamic AAA.AAA.AAA.AAA
object-group service PARTNER-SEROBJ service-object tcp destination eq www service...
Hello
I have Cisco R2811 and multiple Switch 2960, I want to VLAN 90 cannot access to other vlans and other vlans can connect to it (ex : 445,139,...) but it doesn't work, I have configured SVI for Cisco R2811 as follows:
Cisco 2811:
Interface...
Good day,
I have problem with configuration as below:
(a) Switch 2960G (Giga 0/46) ---(3 pair)--- PC << Worked
(b) Switch 2960G (Giga 0/46) ---(3 pair)--- Linksys SE2800 (8 port Unmanaged) ---(3 pair)--- PC << Worked
(c) Switch 2960G (Giga 0/46) ---(...
Good day,
I have Cisco 2911 (EHWIC-1GE-SFP-CU , GLC-SX-MMD, LC to SC Adapter. I want to configure PPPOE on cisco SFP port as diagram bellow:
Cisco R2911 (SFP Port) ---- (SC - LC Adapter) --- ISP
interface Dialer1
ip address negotiated
ip mtu 145...
Hello pieterh,I think maybe this is a solution for my case, I will check and test according to your requirements and update the results soon. Thank you very much. Sang.
Hello pieterh,Sorry for the late reply to your message. Thank you for the information. 1) Try to use the SG90D stand-alone : Please see below2) the PC may be set to "fixed speed" : I already set it to speed-auto3) STP on Juniper/Cisco/Meraki : I have...
Hi Marvin,Thank you for your suggestion on how to change NAT priority, I delete Dynamic NAT and recreate it and it worked. Again thank you so much.Sang
Hi Marvin,
I have configured a static 1-1 nat as your advise
object network PARTNER-NETOBJ-NAT-10.175.4.10---1-1
host 10.175.4.10
nat (Partner,outside) static AAA.AAA.AAA.AAA
I ping to AAA.AAA.AAA.AAA from my home and it worked. After I configure o...