Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to permit a multicast video stream to operate over an alternative IP address (239.239.20.5) as per the requirement from one customer without changing the origin multicast IP that all other customers use (239.239.10.5).
In my LAB I have ...
I have an on going minor issue with the NAT Box-to-box HA feature on 15.5 ASR 1001-X.
If there is a disruption on the WAN side (rii 2 in my case) of the primary router (redundancy priority configured as 120) and therefore a decrement of 100 occurs ...
Hi,
I have created a redundancy group between two ASR 1001-X routers and sometimes experience a problem where return traffic does not get "un-translated" back to the initiating device of the TCP session. The NAT translation table always looks the sa...
Hello,I have seen many 3945's out the box with a memory configuration like 987136K/61440K in "show version", meaning 60MB of I/O memory and 1GB in total. However, I started installing a new 3945 router and it is configured 743424K/305152K, meaning 30...
Hi, I have a crypto map on a WAN interface behind NAT and when I look at the crypto session I only see 3 flows as up out of 4: Interface: *WAN-INTERFACE*Session status: UP-ACTIVEPeer: *CISCO-ASA-IP* port 4500 IKEv1 SA: local 10.10.1.1/4500 remote *C...
I should have mentioned something in my first post. The configuration I posted on this forum is not the full production configuration but something I put together in a lab to reproduce the issue. In the production environment I do indeed have those o...
Hi, Thanks for the response. Indeed, I have a NAT access-list with a deny statement for the LAN->Remote-Subnet.10 deny ip 10.10.0.0 0.0.0.255 172.16.0.0 0.0.0.255 In the end I got this working. There are two WAN interfaces where the crypto map is app...
I have also experienced 50% packet loss over Cisco 4G modems before (normally after initial config) and never got to the bottom of it but a reboot always resolved it and it didn't normally return. Are you sure, re-enabling CEF brings the problem back...
