Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have attached our network architecture diagram. We are using inter-vlan routing for our ntework. DHCP pool for every Vlan is configure on core switch. Each aggregation switch using different VLAN. Some time network chok or hang due to broa...
Dear All,We have Cisco Firewall ASA 5585-SSP-20. Our all servers are behind the firewall. Could it be possible that only those clients only access the servers which are domain joined and do not give access to those whom are not domained joined.
Dear All,We have configured DMZ on Firewall and our DMZ VLAN ID is 2 (172.16.2.0/24). All the server are running on the same VLAN. Now there is a requirement to create a virtual IP on the same VLAN i.e 2 and will configure static NAT with port forwar...
Dear All,We are facing very serious issues. We have Cisco 2505 WLAN Controller and 28 different AP are connecting in our office installed on different location. When one user connect to one AP and than move in the building he/she could not disconnect...
Dear All,
We have Cisco WLC 2500 series and have configured LDAP authentication 802.1x using Windows Server 2016 Active Directory.
We have followed the link given below as guide. But after that configuration, windows user can not connect with the WLC...
Dear Mark,
Thank you very much for the answer. One more question. If we apply this on our core switch do archiving will increase the CPU utilization. I means these commands will have overhead on the CPU and RAM or it consume little processing power.
