Hi,
After configuring SIP-UA on CME, I see that besides the username there are also all my ephone-dn trying to register to that SIP Server.
the ephone-dn is configured with no-reg both commend as below:
ephone-dn 1 dual-line number 234 no-reg both ...
Hi,
Does anyone have experience in using third vendor POE injector for AIR-CAP1702I-E-K9?
From the datasheet of 1702 is mentioned that input power requirements are 44 to 57 VDC.
Can we use Ubiquiti power supply with output: DC 50V
Thnx,
B
Hi,
I recently installed the IP communicator on a laptop with the UC560 system. I have set the TFTP server ip address as the UC520 address which is 10.1.1.1 on the local network.The phone has identified itself to the UC560, can place and receive ...
Hi,
I am having an issue with Cisco Switch SG200-50p. IP Phones on Voice VLAN have connectivity, but PC on data vlan do not have connectivity. On the logs of the switch I see this error:
%CDP-W-NATIVE_VLAN_MISMATCH: Native VLAN mismatch detected on ...
Hi,
I am trying to configure WAN port on UC560, but not sure if it supports encapsulation dot1q?
need to create more than two sub-interfaces on the WAN port.
Did anyone configured such scenario?
Thanks,
Bj
thanks a lot Manish,
it worked as per the bug workaround description, it just needed to restart the CME and now only the specified user is registering with SIP-UA.
Best regards,
BJ
any suggestions on this issue I ma facing?
below is the debug from one extension trying to register to SIP Provider and this goes with each extensions configured on the CME:
REGISTER sip:sip.example.net:5060 SIP/2.0Via: SIP/2.0/UDP X.X.X.X:5060;bran...
Hi Solomon,
Did you manage to do the installation?
Can you please share with us your experience, and any documentation on how to install the platform.
I have to install AutoAttendant. I do not have experience with CallManager, I have experience only ...
Hi John,
What type of IP Phone you are using?
IP Phones should be on all the time, but their display turns off as they are on the saving energy mode, and not on the sleeping mode.
Regards,
Bj