Hi Guys!!  I have  the same problem, but with a NCS5504 with IOS XR. (i've created the token) I reach internet only from VRF INTERNET and a loopback 1. Following the example of this topic, I've tried playing with the source interface and VRF in call-home and http-client, but the result is the same. I think that the config should be someting like this call-home  vrf INTERNET  service active  contact smart-licensing  source-interface Loopback1  profile CiscoTAC-1   active   destination transport-method http  !  ! http client vrf INTERNET http client source-interface ipv4 Loopback1 ! ! So, internet access it working ok... RP/0/RP0/CPU0:Core1#ping tools.cisco.com source loopback 1 vrf INTERNET Tue Aug 27 15:28:51.254 UTC Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 173.37.145.8, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 200/200/204 ms RP/0/RP0/CPU0:Core1# ! ! ! RP/0/RP0/CPU0:Core1#telnet vrf INTERNET tools.cisco.com 443 source-interface loopback 1 Trying tools.cisco.com(2001:420:1201:5::a)... Use specified source interface(Loopback1). Global address not present, using link local addressas source address Not able to get link local addressCan't use Loopback1 as source interface for IPv6. Trying tools.cisco.com(173.37.145.8)... Use specified source interface(Loopback1). Use 186.189.64.1 as local address. Connected to tools.cisco.com. Escape sequence is '^^q'.   The error persits with diffent configs (with or without VRF / source interface) RP/0/RP0/CPU0:Core1#RP/0/RP0/CPU0:Aug 27 15:26:36.378 UTC: call_home[346]: SMART-LICENSE-ERROR: smart_license_req_http_send[164], Failed to send request to all URLs. RP/0/RP0/CPU0:Aug 27 15:26:36.378 UTC: call_home[346]: SMART-LICENSE-TRACE: call_home_smart_license_stats_update[703], Update smart license stats entry, subtype REGISTRATION,stats_type 2 Also i've checked all this items (which seems to be useful) Next Steps: - Verify that the Cisco device can ping tools.cisco.com or the nslookup translated IP - Attempt to telnet from the Cisco device to tools.cisco.com on TCP port 443 (port used by HTTPS) - Verify that the HTTPs client source interface is correct - Verify that the URL/IP in the call home profile is set correctly on the Cisco device via "show call-home profile all" - Verify the ip route is pointing to the correct next hop - Ensure TCP port 443 is not being blocked on the Cisco device, the path to Smart Call Home Server, or the  Cisco Smart Software Manager satellite - Ensure that the correct Virtual Routing and Forwarding (VRF) instance is configured if applicable   from this link https://www.cisco.com/c/en/us/support/docs/switches/catalyst-9500-series-switches/214484-cisco-smart-licensing-troubleshooting.html#anc17 All test were ok... but still it doesn't work. maybe there's a similar bug for IOS XR... ... View more

Hi ! Have you any example or link for route leaking between VRFs for IOS XR ? I've found some info but not so clear. some commands are different and i'm in a stuck. regards Gabriel ... View more