Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am seeing the same error on some 3802i's, running 8.5.171.0. After a restart it showed up about three months later, and then began repeating1-2 months apart. May 9 21:06:57 NCI: E0: Sensor receive failure (0), 22May 9 21:06:57 NCI: E0: Fatal con...
Additional info. Just installed 15.2(7)E on a couple of 3560CX's:= "snmp mib flash cache" reappears if the switch is restarted. Workaround must be applied each time.= snmp changes of any kind require a restart of the switch. Anyone have 15.2.7E0a(E...
I have a 3702I (AIR-CAP3702I-A-K9) that suddenly stopped talking via its Ethernet port. It was in production for about 3 years with no problems. It will boot if I attach it to a power injector, but the switch port connected to the injector never sh...
After reading several similar threads I'd like to start a new one. We are seeing increasing output drops on 2960X and 2960S ports in a specific circumstance: A port is connected to a 6961 or 6941, AND the phone is supporting a computer or other dev...
A couple of years ago we bought some 3560CX-12-PD-S switches as planned replacements for older switches. Got stopped cold with that model when we found the CX line wouldn't work properly with CER. That leaves us without an all-Gigabit 12-port model...
I don't see it anywhere else either. It's crazy that they don't appear on the interfaces list under show interfaces summaryThe replacement 1815W will show you traffic stats on those ports from the controller GUI. But implementing VLAN's differe...
A good idea. We tried that but it didn't help. Don't know if TAC would have been helpful; we replaced the AP and moved on. The switchport worked (and continues to work) fine with other WAP's.
I have the same problem, that the https "webui" page won't recognize any credentials, local or radius. 16.3.6 on a 3850 stack. However we already had the command in place described here as a fix. New ideas?
Wow, yes, that is SO helpful. A proprietary connector requiring an adapter priced at several times the hardware cost which in turn requires you to use a 1980's type serial connector coupled to a serial-to-USB adapter so you can finally plug into som...
Guess you'll have to open an official TAC case and bug Cisco. We just moved our CX's to 15.2(4)E6 and the STACK light is still flashing away.
In a related note if you install that version, it adds and/or removes some config commands. Be sure to c...
