Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm part of a group of sites that are trying to multicast to each other. I'm showing on the neighbor table and in mroute on one of the routers between locations, but am unable to get my streams to be picked up by others. I *can* see the stream from o...
I'd put this on the getting started board, but it's too weird:I'm deploying to a site that will have a single ISP-assigned address. This connection will be used by users on the LAN for standard internet access, and by two dedicated multicast sources....
Trying to set up an 891 to serve as a gatway for a LAN and a v2 pim router for some multicast sources. The result is from a marriage of two (possibly incompatible) trips through the forums. The last piece of the puzzle is this:If I set the the isp-fa...
I've missed what I surmise to be a basic yet critical step in configuring a small 891 isr. So basic that I've put off asking since Friday:Here's the overview which might be enough to skip the long version:I can ping and resolve WAN-side things from t...
1. This 199 IP, is it part of your AS ?I assume yes.2. Does this peer have pim enabled ?also assumptive yes3. Do we have pim neighborship to that neighbor (show ip pim neighbor)?my router shows this as the only neighbor:Neighbor Interface Up...
Didn't even consider how confusing trying to mask my addresses would make things.Short version:THIS router, the one I'm working on, is 199.8.201.100next hop is my ISP's router, 199.8.201.97 (which is the default route/mroute)RP is somewhere at the IS...
In all its glory. Currently: yes to inet access, no to showing as a pim neighbor upstream.ITHOR#sh running-confBuilding configuration...Current configuration : 4248 bytes! Last configuration change at 18:21:44 UTC Thu Aug 29 2013 by cisco! NVRAM conf...
Thanks again for chasing this, John!Version is 12.4(22r)YB3. Also, the setup (I'm not native to cisco or routing) is a mashup of first getting pim out, then finding out there would only be one LAN address and scrambling to get commodity access up. I'...
