Let me double check the previous discussion below. ---------------------- Subject:  How to configure traffic shaping on the DMVPN spoke end with higher bandwidthhttps://supportforums.cisco.com/discussion/11710366/how-configure-traffic-shaping-dmvpn-s...

Hi, Does Dialer interface support CEF switching in ISR platform 15.5M&T train ? In very old documents indicate dialer would not support CEF, but fast switching. I cannot find out latest update information in terms of this point on CCO now. Here I ca...

After CSCtr26978 : PfR Simplification - Phase 1 -1, effective with Cisco IOS Releases 15.2(1)S, 15.2(3)T, and Cisco IOS XE Release 3.5S, the set mode select-exit command and the best and good keywords were removed. With CSCtr26978, the default behavi...

Now I want to make sure if  PI can still manage clients (IP / MAC address) when there is HUB device between SW and client PC ? Regards, Shunta Tsuchida

I want to make sure how many Backup NHSs we can setup on spoke in one Tunnel when we refer to  below doc. From what I take through so far, there is no good value for this max value. Chapter: DMVPN-Tunnel Health Monitoring and Recovery Backup NHS ht...