Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team: Hope you are doing well during this COVID-19, may GOD Bless you. I have one requirement in ISP where one location globally different than other and customer requires Tagged VLAN example (123) and want to pass all his vlans from one locatio...
Hi all, hope you are doing well.
I have a very strange issue and puzzle if someone can help me as it have taken my 2 weeks but still I am back to square 1.
we are providing connectivity to 1 cutsomer which involves our 1 CPE and other CPE is provid...
Hello,As per old document,the Cisco Catalyst 3750 Metro Series does not include StackWise stacking capability and cannot stack with other Cisco Catalyst 3750 Series Switches.can someone please confirm it is still same or did they sort our this thing ...
Okay dears, I have tested it in my ISP new requirement and it worked with corresponding Huawei device where they are using VPLS. It seems I opened the case on wrong section as 120 people saw it but not a single one replied Thank you. Kindest regard...
As deepak explained why D is correct, regarding E "ip ospf mtu-ignore"override the process of answer D and disable the checking of MTU mismatch when it receive the DBD packet so it is also possible solution and that is why it is correct.
For more y...
The main issue that you are facing is that R1 R2 R3 don't have complete information of each others connected networks and static routes. What is happening is that when you trace from R2 taking the source of your Gi0/1.8 interface the out traffic goes...
The command to run OSPF in an interface mode is "IP ospf (process ID) area (ID) "
For more you can go through the below document.
https://www.cisco.com/c/en/us/td/docs/ios/12_0s/feature/guide/ospfarea.html
Thank you.
Kindest regards,
Uzzi
Please remove the static route from NTT-Router also one more thing I observed that out of 3 ISP's you are doing prepanding for 1 which I cannot see in your BGP config which you shared. strange thing is you are prepanding to AS 10204 and then they are...
