Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We recently bought a LMS to Cisco Prime Infrastructure 2.x Upgrade because we had plans to migrate LMS 4.1 to Prime Infrastructure 2.0 In fact, we did not do the upgrade, but we installed Prime Infrastructure 2.0 on a new, separate server. We ...
Good evening,I have setup Cisco Prime Infrastructure 2.0 and, though I have added manually my 4 network cores as devices without any problem, I can't get a single trap or a single SNMP information to be pushed into my Cisco Prime Infra.Here is my ...
Hello,What is the configuration needed on an etherchannel PAGP trunk to enable dual active detection for VSS on 4500X ?I have enabled it on my vss in global mode but I don't know which vlan to allow on the trunk towards my switch in PAGP.Is it the na...
Hello,I have a Cisco Catalyst 4500-X connected to an ISP lan to lan link. This link does exclusively L2 transport.As per my company needs, I have to transmit my local vlans to the remote sites located behind this L2 link. To do so we chose to use Q-i...
Hello,I have installed a version of Cisco Prime Infrastructure 1.2.11 with a kickstart .ova file on my production network.Everything goes fine and I follow the instructions for installation ; i can ping my Cisco PI server and ssh into it as admin.How...
Hi Henry,Last time I checked with TAC (around February) it was still impossible to do without reinstalling everything. It seemed baffling to me, but I could not find anyone who has successfully done this without damage.
Thank you Afroz.Would this mean that my LMS 4.2 License Kit is useless because I already have a LMS 4.1 installed ? Also, how do you do device splitting between PI and LMS ? Thanks
Hello, I have the same problem. I created port-groups for my "uplink ports" and deployed the template "interface health status" on those port-groups. But when I set up my "link down" alarm as "Severity = Critical", i still get tons of alarms for all ...
Hi, I'm bumping up this thread because I am running into the same issue in Prime Infra 2.0 Were there no evolutions on this situation ? I can't see any config files in the disk:/tftp folder or any other folder. Is there a way maybe to redirect those ...
