Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning, all,I have a 2504 Wireless LAN controller and several 2702i AP's configured and working, but using a static WPA2 key for user access on our internal LAN. They've been wanting me to change this so that users will use their Windows AD cr...
Hi, everyone. Was hoping to get some advice and assistance regarding two issues with a brand new SG300-10MP our company recently bought.1. I've been having difficulty getting a proper trunk port to work on this, as compared to the Cisco Catalyst 29...
Hi, all,I've just started working with a 2504 Wireless LAN controller and bunch of 2702i Access Points. Spent a lot of time in the controller and working with getting the access points set up and all that. So far, I have a test WLAN set up, ap-mana...
Hi, everyone,I'm still in the process of learning about Cisco, but I'm now tasked with a problem that I'm stuck on and up against a time limit to fix.At our home office, we have a pfSense box providing IPSec tunnels to some remote locations and these...
Hi, all, I've run into a problem and I'm not sure what I'm doing wrong, so hopefully one of you experts can point me in the right direction.I'm installing a new Cisco 2911 and wanting to configure G0/2 as a dedicated interface for management. Our ma...
SUCCESS!Looks like after I fixed the wildcard mask from 0.255.255.255 to 0.7.255.255, the tunnel was configured properly. We kicked it and restarted it and traffic began to flow!I've corrected the access-list 101 to the right wildcard mask so everyt...
I've re-checked pfSense and the Cisco router. Found that my wildcard masks didn't quite match up. The network at the home office is 10.0.0.0/13, but I was doing the equivalent of a 10.0.0.0/8 on the Cisco. I fixed this, but still no traffic passin...
PROGRESS!From my test machine, I'm now able to ping to a public IP address. I did have this in my config at one time, but might have removed it because of the VPN problems.However, I'm still unable to ping anything in the 10.x.x.x subnets on the oth...
I do not have a Cisco device on the other end of this tunnel from the 1921. The other endpoint is a pfSense box, that as far as I can tell, is configured correctly, but no traffic is passing and I still have no Internet connectivity from my test wor...
