About chrisinternet

chrisinternet · 09-02-2016

Hi everyone, I had a routing problem through my VPN. My office (yellow): public IP address: 70.1.2.3 LAN: 10.1.1.0/24 Router: CISCO WRVS4400N My Datacenter (green): Public IP address: 180.1.2.2 (with Port forwarding 80 to 10.2.1.100 - www.company....

chrisinternet · 12-02-2014

Hi,I'm a new Network admin, and I have some configuration questions about my installation (see attachment).I have 3 web servers behind a router.Public interface: 3 public ip adressesPrivate interface: router on a stick config ( 3 sub-interfaces, 3 di...

chrisinternet · 10-05-2013

Hi everybody!I'm looking to acquire knowledge in IP telephony and VoIP. I'm testing some configuration back to back and I have some problems with a T1 CAS link. Here is my situation:On each side, I have two analog phones connected to a 2811 router. T...

chrisinternet · 12-08-2014

Hi fogemarttt,Thank you for your help.It works nice for the NAT, but I need to change my configuration, because i can't filter URLs with my router. I'll probably keep static NAT with ACL only and put firewalls on servers.

chrisinternet · 03-03-2014

Hi, this line sounds bad:*Mar 3 09:42:16.171: //98//TCL :/tcl_PutsObjCmd: TCL AA: -- ERROR: Mandatory parameter voice-mail does not exist --try :param voice-mail 1000 (or a free DN)even if you don't have voice-mail...and this line in your configurat...

chrisinternet · 10-05-2013

Thanks for your help Paolo,This is so logical! I've think about this when i wrote this message...I'm back on tuesday.I'll try with one side fxo and fxs to the other!thanks a lot

Member Since	‎10-05-2013 08:06 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	6

User Statistics

User Activity

No routing through Site-to-Site VPN - WRVS4400N - RV180

Best practice for web servers behind a router (NAT, ACL, policy-map, VLAN)

Problems with a T1 CAS back-to-back configuration with fxs port

Hi fogemarttt,Thank you for

Re: B-ACD AA not working

Problems with a T1 CAS back-to-back configuration with fxs port