Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I tried to update an IE3300 with the DNA center. My problem is that the DNA Center writes the new image to the flash. But the Switch works and boots with the SD flash. but there is no new image!!!Does anyone have an idea to solve the problem
Hello,
i will migrate a ap 2802 from aireOS WLC to Catalyst 9800. I have a C9120 EWC. I updated to version 17.03.05b.
The 2802 will not connect to the controller.I think he can't find the right image.here the logging:
Discovery Response from 192.168....
Hello, I have a REP ring that is connected to a switched environment. What should be noted that REP sends TCN in the MSTP Domain ?If I simulate a break in the ring, the core switch (MSTP Domain) keeps the client mac on the wrong interface until the ...
Thanks for the reply.
I'm currently looking for a solution to change the boot variable. ?
I get the message: WARNING: The BOOT/config file path points to theSD flash card. The environment variable(s) issaved onto the SD flash card
DNA is 2.3.5.x /ie3x00 is 16.12.3 to 17.6.5
the problem is: is the boot variable boot flash:ie3x00-univers......bin - the update works without any problems
some switches have the boot variable boot sd-flash:ie3x00........bin - It just doesn't wor...
The image is only available as .bin in the DNA Center.
the old image is also .bin in flash and sd flash
the dna center only writes the image to the flash: and its preset thereA sync of the image to the SD flash is not possible
Hello,
I can not configure Streaming Telemetry on EWC
https://www.cisco.com/c/en/us/td/docs/wireless/controller/ewc/17-10/config-guide/ewc_cg_17_10.html
the first time I did the update with http. here you could only choose one AP image.With ftp you only specify the path and he downloaded the appropriate ap3g3 file.
