Hi I'm having problems with Sip Trunk Between CUCM and Asterisk, in the route pattern i have defined a route for numbers 86XXX in the Asterisk Side they can dial to CUCM Users with no problems, and when a registered Phone on CUCM try to dial an Aster...
HI
In the WLC the users are authenticating vía radius and i want to reserve bandwidth to specific user, i want to know if that is posible my wlc is 5520.
Hi
I'm trying to solve this problem:
The authentication method in SSID "WIFI" is vía Radius, the users join the network correctly, but if the radius service fail the users are automatically disconnected...
1. In Wlans -> Edit 'WIFI' Advanced tab,...
Hi everyone
I have a switch Catalyst 3560x with version 15.0(1)SE3 and i have created mac address access list, my goal is only the specified mac adresses on access list will allowed to join vlan or port, here a small segment of my acl:access-list 70...
Hi everyone I have a cisco firewall ASA 5515-X and i need to generate daily reports of bandwidth usage by ip address and i want to know which system, tool, or software you recommend for do this, thanks!!
Hi Rasika
Thanks for your reply, that i trying to say with "reserve bandwidth" is for example:user1 = 5MBPS
user2 = 10MBPS
user3 = 60MBS
the users are from Active Directory and authentication by Radius on WLC, the users access the Wifi Network wi...
Fixed with these:
Switch(config)# mac access-list extended allowed-list
Switch(config-ext-macl)# permit host aaa.bbb.ccc.ddd anySwitch(config-ext-macl)# permit host eee.fff.ggg.hhh any
Switch(config-ext-macl)# deny any any aarp
Switch(config-ext-macl...
Thanks, according with read article i need update from my current version 8.2.2 to 8.2.3.9 for get support for sha256RSA, the question is if the upgrade for the firmware is free or i have to buy the firmware from cisco support?Thanks!!!
