Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I use two AP 9120AXE-E with Cisco Embedded Wireless Controller, I use the latest version of IOS on each AP.Both APs are configured to cover the house with the same SSID in 2.4 and 5Ghz.For some reason, my phones can't authenticate correctly on ...
Hello,I recently updated the IOS of my switch via the web interface.After flashing the switch, I find myself with a minimalist interface instead of the usual web interface.Do you know how to get back the previous interface? Which version should I dow...
Hi to all,I use Cisco Switch 9300 (WS-C9300-48P-E). I have three VLAN setup on different port.When i'm connected on console port, i was able to ping device on VLAN 19X.XXX.XXX/XX and the default GW, but i'm not able to ping WAN IP.If i ping 19X.XXX.X...
Hi to all,I have Cisco Switch WS-C9300-48P-E, port 19 on this switch doesn't work, if i connect a device on this port (POE device or not), no uplink, no reaction from Cisco panel, no notification into console... so i dunno how to fix this issue.Port ...
Hi to all,I have Cisco Switch WS-C9300-48P-E, port 19 on this switch doesn't work, if i connect a device on this port (POE device or not), no uplink, no reaction from Cisco panel, no notification into console... so i dunno how to fix this issue.Port ...
I just reboot AP , connexion was negociated at 1000mbit instead of 100mbit... and all is fine...But... i have this error message in red after a new show tech wireless Do you know how to fix it please?
Here are the results.In the AP Message Summary, I discovered this message...It's strange because both APs are connected to a Cisco 9300 switch. I don't understand why it tells me that AP 1 is in 100mb mode!Ethernet: AP has Interface on 100 Mbps mode....
I'd like to point out that I didn't have this problem before setup profil with the hardware, and that the APs haven't moved.The antennas can't be a problem.Can anyone remind me how to identify one of my APs? i think there was a method to make an AP b...
I didn'y make trunk between swtich and firewall, my pfsense has 4 ethernet interface, one for each vlan, and the last for ISP.so each vlan attacks a firewall interface
