Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Checking the change configuration audit in a ISE 2.7 deployment (under Operations > Reports > Audit), we see a lot of events saying "the federation link was down".Clicking on the event does not provide more information.Can someone explain what th...
There is a workaround for this bug, provided by a TAC engineerSSH or console to AP and enter the following commands: Debug capwap console cliErase /all nvram:confirmReloadSave config YES and confirmThe AP would then join the controller.
Hi,we have a IR829 with an integrated AP803. The router works fine but when we reverse telnet in the router to gain access to the console of the AP, we see that the AP803 is stuck in ROMMON.When we do boot, the AP tries to boot its firmware but after...
For info: there seems to be an issue with FF 129 and ISE 3.1 (and probably also other combinations of versions) where the Rule Name column is very narrow when you display an ISE policy set. It is so narrow that the Rule Names are printed vertically a...
It looks like everything goes fine until R1 receives MM4 on udp 500. Then, since R1 has detected the NAT device between the routers, it sends MM5 on udp 4500:416871: Mar 28 15:42:24.471 UTC: ISAKMP:(1501): sending packet to 222.222.222.222 my_port 45...
Hican you post the output from the controller after you enter following commandsdebug mac addr <base-mac-of-the-ap>debug capwap packet enabledebug capwap event enabledebug capwap error enablethen wait until you see the config request packet in the ou...
>> So it is good to know if the cert is not correct then the WLC will not even download the cert.It will download the cert but it will discard it if not well formatted
@William Foster wrote:Actually to expand on my problem. I am not even able to TFTP the cert to the controller. I am getting a file transfer failed! I am certain that TFTP is not being blocked. However when I look at the log I see this below error. Tr...
