We are facing issue with our 6807-XL Details:
Supervisor: C6807-XL-S6T-BUNModule: C6800-32P10G and C6800-16P10G
Software Version: 15.4(1)SY
We are facing issue with SFP:
SFP: GLC-SX-MMD and GLC-T (It shows unsupported SFP module an...
We have following controller and Access Point in our wireless environment,
Model No. AIR-CT5520-K9
Software Version 184.108.40.206
We have 2 Gbps internet up-links for these wireless clients, we want to t...
We have Air-AP1852i-x-k9 APs and want Configure Cisco Mobility express before moving to implementation want to know the image version of that access point. I have connected the console direct to access point. Its a new access point. Its aski...
Hi All, I am looking to upgrade my WLC 2504 from Software Version 220.127.116.11toSoftware Version 18.104.22.168is there any issue i can face during this process?? How i can check FUS first, do i have to update FUS then image or i can go directly to Software ...
Hi all, I have a very basic question, how Lightweight access point work after joining WLC. when client will connect to AP after successful authentication how client device will work, every time when traffic for that client have to pass from WLC or n...
in Access SW
Put in global config. : no ip dhcp snooping information option
---- by default switch adds option 82 in DHCP packet.
there is a complete discussion on following link:
Hi All, These settingwork for me: from GUI > Security > AP Policies > SSC and MIC certificates are checkedfrom GUI > Controller tab > Advanced > Master Controller option is enabledBut i don't got the point, i never use to check this even all other co...
Thanks for response. Yes all the APs were running and now I am getting this massage. The code was update 20 days ago. Everything was working fine but now I am facing this issue.. what I can do to resolve
Hi I have the same issue, today i rebooted the controller after that no Access Point is joining the controller. While debug i can see same logs as given above. I have configured option 43 and 60 as well on cisco switch. Pool commands are: ip dhcp po...