Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been playing with Auto-Deploy in vSphere 5, and it works great with a standard vswitch. However, when I try to use auto-deploy with the Cisco Nexus 1000v, I am having some trouble. The auto-deploy relies on host-profiles, and I wanted to kno...
Hello,I have an OSPF and EIGRP network that I am working on converging. However, my route-map filters do not seem to be working correctly. The general setup is as such:OSPF:192.168.0.0/24192.168.1.0/24EIGRP:10.10.5.0/2410.10.6.0/24Network that join...
I have a Cisco WS-C2950G-12-EI and I have incrementing throttles on my VLAN interface. How does this impact the performance of the switch, for access ports in the same VLAN 50? Is this a concern?Vlan50 is up, line protocol is up Hardware is CPU I...
I have a 3750 connected to our providors 3400. The connection had some issues this week, where I stopped receiving input packets, although the link remained in up/up state. Bouncing the interface did not bring it back up. However, changing the neg...
I have a 3750 that has a TW circuit connected to it. I stopped incrementing packets input, but the link was up/up. When I escalated to TW, they said their side was down/down. I didn't think this was possible?TW said they would bounce the interface...
FYI: I solved my problem, and wanted to chime in to this thread. If you run a 'show port-profile usage' to see what interfaces inherited the config, it should list the port-channels that utilize it. In my case, running a "show int po xx" determined...
I figured out the problem. There is a field in the host profile section:Networking configuration -> Host virtual NIC -> switch : vnic : management -> Stateless boot properties for virtual NICFor some reason, that was set to VLAN 200, while my PXE bo...
I am seeing the following error in vCenter:Name: Reconfigure dvPort groupStatus: Cannot complete a vSphere Distributed Switch operation for one or more host members.Error Stack:vDS operation failed on host 192.168.1.127, got (vmodl.fault.HostNotConne...
Louis,Thanks for the response. I have already gone through the following steps, with no luck:1. I added the VEM offline bundle to the image2. I added my host to the 1000v3. I updated my host profile4. I removed the AutoDeployRule5. I created a new A...
