Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear team, Could someone advise me what could be. I have created new stack based on Cisco 3750.I have three stacks, due to increasing q-ty of users, was made decision, to buy new switches.I have download from on the stacks config and uploaded to new...
Hello everyone, Could you please advise me what can be wrong. I have stack on Cisco 3750v2-48ps. I want to connect additional switch, model is the same, but IOS is different.I've decided to use command "archive upload-sw tft://xx.xx.xx.xx/image.tar",...
Hi team,I have an issue with the stack basing on Cisco 3750 switches.Today on one of them, something went wrong and all ports are down.Could you please advise, what happened? In what direction I should work to find root cause?thank you
Dear team,Today in the morning, I have faced with the issue that UCCX Engine in Partial Service on UCCX 8.0.1.10000-11.I can manage Application and Promts, Scripts.I cannot manage Resources, skills, CSQ.Yesterday I've deleted not used skills.My call ...
that is what I am trying to do. I am trying to donwload IOS on the TFTP server from Stack and upload this IOS to new switch.But, when I am trying to download IOS, it give me an error "Warning: Unable to determine image running!"
Hi,I have found out what is the root cause.In stack, I have 4 switches:1. Member2. Master3. Member4. MemberBut right now I have next picture1. Member - status "Ready"2. Master - status "Ready"3. Member - status "Provisioned"4. Member - status "Ready"...
Hello Matthias,I am facing with the same issue, could please advise me how you manage it?You include Application User from the UCCX into admin rights on UCCX or on CUCM?Could you please provide me set-by-step instruction?
Hi Amanso,Lic:1. IPCC40LOCK20110815120326912 - 16.08..20112. IPCC40LOCK20120406021208485 - 06.04.20123. IPCC40LOCK20130301073652774 - 01.03.2013CLI:I cannot run those commands, please check two attached files.What output do you need?"Host Name : U...
