Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hiwe just configured the cisco MRA the problem that cisco jabber cannot connect to phone service from internet. But IM & Presence work fine. but services (IM , phone and unity )from Internal network are works fine.I created the Expresway E - C FQDN i...
Hi
i install a Prime 3.0 with evaluation license but when i try ADD Device for switches such as 3850 and 3560 , i have problem and see wrong cli credentials invalid Login password While I'm sure about User and Pass of Switches .also i see output deb...
Hii have a scenario include Bladecenter -->nexus 4001--->nexus N5K96UP--->MDS 9148--StorageI am seeing a very high "rx Pause" on the Nexus 4001 side portchannel connected to nexus 5000. Here is the output:SW-4001i(config)# sh int port-channel 10port...
HiI've configured this topology for FCoE on 5kinclude IBM BaldeCenter with HS23 LOM Emulex , 2 Nexus4001i , Nexus 5k and MDS 9148 and IBM storwise .I've configured Fip-snooping on the 4001 and Fcoe on the 5kplease see output config4001i______userna...
Hii config radius in the ASA and also i set interim update for sending start stop updates toward radius client . i got a debug command on the asa but i didn't see any update in the output file.thanksdynamic-access-policy-record DfltAccessPolicyaaa-...
Hi AnthonyI've tested with this tool before and it didn't show any problems. Of course, this tool is not available right now and it is having problems.thanks
Hi
i solved this issue .
please remove the prompt or same thing from device .
aaa authentication password-prompt P:aaa authentication username-prompt U:
prime don t recognize this prompt .
Hi Rajthanks for your supporti have a storwize connect to MDS by 4 I/O in the downstream .when I do config Qos for a Pww of a blade to Pww of storwize this low speed (10)M gets over 600 M and stop counter of rx pause in the 4001. I have 14 Blade and ...
Hi Jimthanks you for support .your previous post was very helpful.I've changed the configuration in the 4k please see the attachment .each Blade has two nexus 4k and two 4K connect one 5k.window server in a blade see LUN of storage and also attach to...
hi jimthanks for your support.I did change that you said , i did port-channel between the N5K and the N4K.But still have problems. This scenario is not now under operation.sometime traffic between esxi and storage is good but This relation is sudd...
