Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Do we have any option in Cisco ISE CLI/API/NETCONF for managing local server certificate? When i say manage certificate, i am looking for create csr,import server cert, bind csr, specify cert purpose, import ca cert etc kind of operations. I w...
Hi Folks,Can I configure Cisco CSR 1000v virtual routers via Cisco FND PnP Service? When i tried, i get "PnP Service Error 1702" (I/O error). Is there anyway to overcome this? What is this error about?I understand this model is not there in FND's sup...
Hi Guys, Let me explain one scenario here.I have four 7206vxr (NPE-G1) routers in my network. Currently all of them are running fine with IOS image c7200-a3jk9s-mz.124-25f.bin.Recently we have decided to upgrade these devices to 15.x series and we up...
HI,Can anyone confirm the interface level storm control command will work in 2811 router which is runnning with c2800nm-advipservicesk9-mz.124-15.T7.bin router?I am facing high cpu on this router due to interrept traffic, and found high amount of bro...
Hi Guys,i have a problem here, i have Two WS-C6506-E model switches. In both switches i am getting below outputs. I some module i am seeing minor/major error.Switch-Pri#sh moduleMod Ports Card Type Model Seri...
Hi Guys, One follow up question, since this scenario matches with my case as well. If the personal store contains multiple certificate how anyconnect will pick the right certificate? I tried this scenario, but anyconnect automatically picked the righ...
Hi Joseph,Sorry for the typo error. I meant interrupt traffic. I have 4 fastethernet ports which is currently in active state. So aggregate bandwidth would be 400mb right? And totoal utilized bandwidth would be approximately 14MB. But my CPU utilizat...
Hi Caures,I too found that feature in feature navigator. But when in type the command in interface configuration mode, i am gettting "% Unrecognized command" error.Regards,Anand
Hi Leo,Thanks for your suggestions.I have already completed first 3 steps which you suggested (in Switch 1). But still problem was excisting. I raised RMA for one Sup engine. I will update the result post the replacement activity.But still i am havin...
