Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I don't know why but I can't ping the HSRP address 10.xx.xx.1 from BIO-N5K-22 and LIMS on the right side (see diagram in attachment). All other device are correct (ping ok)VLAN 200N5K-11: 10.xxx.xxx.2 (HSRP listen)N5K-12: 10.xxx.xxx.3 (HSRP ...
Dear all,I have 2 Cisco Nexus 5000 with each 2 Nexus 2000 in FEX Mode. My Vlan are all in fabric mode.I would tried to connect a catalyst 3750-X and a nexus 2K together in trunk with filter vlan.NEXUS 2000 <== Port-Channel ===> Cisco 3750XN2K :Po: sw...
Dear all,I tried to configure a port-channel between a nexus 2K (2FEX) and a brocade VDX (VDX6710).As you seen below, my configuration :N2K-------Po10switchport access vlan 200Eth101/1/6switchport access vlan 200channel-group 10 mode active (used LAC...
Dear All,I'm working on a new architecture Nexus. I'm wondering if I can build an architecture as shown in attachment. All my Nexus are in fabricpath mode. I only know if we can create a link with 40Gbps between different nexus and how to.Thanks for ...
I can confirm that the bug exists in version 10.4.5 and the issue is fixed with the following commands. However, the alarm reappears after a reboot.
(config)# feature frequency-synchronization
(config)# no feature frequency-synchronization
(config)# ...
Hi,The VDX is used as a switch. With the command 'spanning-tree shutdown' from the VDX, we didn't try to up the link (as shown in my original message). May I use the spanning-tree bpdufilter enable of my interfaces from N2K ?Thx for your help.Matthie...
Hi Reza,I only forgot to say that my brocade is directly connected to my N2K. It's working fine with a catalyst switches but not with the VDX brocade. N5K | | N2K N2K | ...
