Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I am running into a very wierd behavior.
I have 2 internal networks (inside, dmz) that I used static nat in order to get data to flow between the two networks.
but whenever the static nat is applied, the hosts on the dmz side seems not able t...
There are two CME sites, site a and site b, connected by a lease line / mpls / vpn. The two sites are able to ping each other.
The end goal is for site a to dial a prefix, let's say 0099+site b local number, so that a call will be forwarded to site b...
So I ordered a 2911 with all the voice modules and licenses preloaded on it.
This is a list of thing that have gone wrong
1. The CUE firmware loaded is 8.5.1 the CME version is 10.5 according to the official Cisco matrix I need at least 8.6.7 befor...
Hi all,
I am trying to create a VPN access by using ASA5505 and using VPN client
We have the ISP which give us 4 public ip addresses.
The ISP dmarc is connected to a C2921, which use the first public ip address on its outside interface.
i did a stati...
Hi all,We have a 2911 that is running CME on top of. The router time is correct but within the CME GUI it is one hour fast. I checked all the setting with timezone and others and it seems to be correct.In the GUI i tried to change the time and it wil...
Thank you for the response Jaime,
so assuming 6 is the number you dial to get outside:
Site A
dial-peer voice 10 voip
destination-pattern 00996...........
session target: ipv4:SiteBIP
Site B
dial-peer voice 10 voip
incoming called-number 00996........
for anyone that is searching for answers, this is what I got:
You need to upgrade the CUE firmware. I don't know what Cisco is thinking loading a firmware that is not compatiable.
2. Config Express does not work and CIsco advised on reload the CCPE ...
hi Cisco Freak,
this is where my network knowledge becomes limited, but I always thought that when you VPN in, the device you are using brokers the connection to the inside network. Can you point me to the right direction of why is a NAT exempt needs...
Hi,I did enter the time-zone info under the telephony-service configuration mode. just to be sure i did it again.same effect, the router from cli will display the correct time, the phones will display the correct time, but if you goto http://routerip...
Thanks you all for the response. No the router and isp stays the same company. ISP said the circuits are clean. But there are unsure if the numbers have been migrated to the new circuits yet, but i was told that wether the numbers are migrated or not...
