Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I’m having some difficulty getting traffic shaping to work. I’m trying to setup a basic traffic shaping policy to limit the download speed from the internet, I am using a broadband speed test to check if the policy is working. I am able to get t...
Hi I’m attempting to create a basic traffic shaping policy in a lab environment but I can’t seem to get it to limit the download rate? I can successfully achieve this with policing. I am testing the speed restriction using a broadband speed testing w...
Hi I’m having some difficulty in understanding the behaviour of zone based firewalls on a 887va router, I do not understand the implications of including the self zone in a zone-pair. It seems that if you include the self zone in a pair with any othe...
Hi, I may be a million miles off but i'm trying to route all traffic at our spoke sites through to our hub site and subsequently through a firewall etc. so I obviously need the gateway to change when a dmvpn is established. I am considering using pol...
Hi all, I have a couple of questions about routing protocols over DMVPN. I'm a bit rusty so I'd appreciate if there's mistakes in my understanding if you could correct me. I understand the EIGRP doesn't ordinarily use the next hop field, receiving ...
Hi Thanks for this, I have attached the same policy to the outbound dialer1 interface and analysed the results from a broadband upload speed test which still seem to be unaffected by the shaping policy. I would have thought that I would see some impa...
Cisco 887va router, it seems odd to allow you to configure this? might this be the same with NBAR? as I can configure the service but our management software reports that it is not supported on the router?
