Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking to add the anchor per the Cisco steps.... Step 2In the Wireless Networks area, click the relevant WLAN or RLAN and click Mobility Anchor. But it is not listed in the WLAN section.New to the 9800 series, been working on AirOS for awhile and st...
Ran into a small problem with ACS 5.5, when assigning Permit commands in the Command Sets I wanted to be able to Permit the "show" command with all the commands within that group being permitted. In ACS 4, I was able to check a small box labeled "Per...
Yesterday both our Nexus 7000's rebooted unexpectedly. Both gave us the following reason Reason: Reset triggered due to HA policy of Reset System version: 6.1(5) Service: dhcp_snoop hap reset Did some Google searching and did not find much. Tha...
We have a issue where Cisco Prime 4.1 is using alot of swap space. We have 16 Gigs for it and it will use most of it. Also I am running out of Drive Space. I have all of my pruge settings correct, but still having issues. Any ideas? Thanks.
Thanks for the response Vinod,Solaris 10Using df -kh we see that swap is around 15GNot running out of disk space for files and directories, just using excessive swap space. Thanks
Yeah I feel dumb, lol, I rechecked all of the credentials and not only was I missing the enable, but they were incorrect also.Thanks for the help, now still need to figure out the packet capture. Even thou I do not think I will be able to get it to w...
I might be saying that incorrectly, when I state two-factor, I meant that you have to put in a password in to get enabled. Is there a setting in Prime to put this in? Thanks for the response.
