Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I get the following error when creating or modifying an LTE profile on my cisco router. MidLand#cellular 0/1/0 lte profile create 3 h2g2 noneAccess Point Name (APN) = WF.GW5.VZWENTPUsername =Password =Authentication = NONEProfile 3 already exists wit...
Hello, I have a few 2960X switches I need to send to cisco for RMA'ing, and I am trying to remove flexstack modules out of these switches. I am not sure why these screws are on so tight. In the process I stripped most of them. The reason why I am att...
Hello,
I am looking for some resources regarding how typically last mile SP are designed and some pros and cons of designing last mile/access for a service provider. In particular I am curious about cable internet last mile deployments. Thanks!
So when i apply an aggregate to an ebgp peer in as 10 for specific prefixes 172.16.2.1/24 and 172.16.3.1/24 I used the aggregate address of 172.16.0.0/22. So the ebgp peer that receives the aggregate sees 172.16.0.0/22 as expected but when i try to p...
I want to buy a cisco SFR-10G-SR ethernet port module and I found out through you need to buy a server, the server I need to buy does it need to be a already 10gbps server or can I take a cheap server and just replace the module already in a cheap se...
You will need to setup MPLS VPN and get your route-targets configured. Route-targets allowed for certain traffic to be imported and exported from a given VRF. You will need to setup multiprotocol BGP with the VPNv4 address family extension. http...
They will just create subinterfaces on the links between the PE's, like VLAN 100 for instance I would create a subinterface like g0.0.100, then configure the correct ip addressing information from there. The subinterface config is not much different ...
Not related to what you are asking necessarily but you might want to consider VPLS, if the customer wants to add more sites, point-to-multipoint would work out better in this case. Instead of creating abunch of site-to-site links everytime a site get...
I would say QinQ is an L2VPN implementation using MPLS. Not an L3VPN MPLS technology. VRF's sounds right, that would be a possible solution in this case.
