Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Full message as the switch starts to boot, and it sits there for a couple of minutes at least:"Both links down, not waiting for other switches Switch number is 1"This switch isn'...
My config was: kron policy-list DailyNetworkBackupscli show run | redirect tftp://192.168.100.96/NetworkBackups/4321-Daily.cfg!kron occurrence DailyNetworkBackups at 23:00 recurringpolicy-list DailyNetworkBackups It ran last night and now my config i...
The old switches had fastethernet interfaces and the new switches have gigabit interface. The new switches are using the same IPs as the switches they replaced. CER still shows the old fastethernet interfaces. Is there a particular method of refreshi...
I'm doing inventory of my network devices across 7 routers. My perfect world would be to setup a kron on each router to run a "show arp" using attributes to pick the mac addresses out and then tftp it to my server. From there I could dump that into a...
I'm replacing my 5516 ASA's due to the forced RMA. Anyways, I'm in an active/standby configuration. I replaced the secondary and failed over to test, all is good and I'm running on it. So the state I'm in is Primary/standby and Secondary/Active.
No...
Thanks, but either suggestion works. This is a new, out of the box, switch. I have been prestaging them, and all the switches have the "switch 1 provision..." command in the running config, with no other entrees other than itself. The pause is still ...
Marvin, I have used your 3 step method for standalone FWs before and it work but, does this also work for an HA pair? IOW, just do your step #2 twice with #1 and #3 staying the same?
Thanks, I have 33 switches and wasn’t sure how long it would take to refresh so I didn’t know if I could do it on the fly. With 33 switches is this something I should do during a maintenance window? Also, is there a way to update the switches one at ...
