Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can someone tell me why Cisco ACS would be better than Microsoft's version of RADIUS? I'm looking for overall answers - such as Cisco can do IP Pools but Microsoft IAS can not.Thanks!
Okay, we've had this happen twice now, so it was not a fluke. Here's the situation:We have 3 Cat 3524XL switches all running the same IOS 12.0(5)WC7. We also have 2 Cat 3550-48 switches running 12.1(11) and 12.1(13) IOS.The are all hooked together ...
Hello all,I uploaded a new PDM and new IOS image to my PIX 515. The question I have is, when I reboot the PIX for the image to take effect, will the PIX reboot and come back up automatically as routers do? Or do I need to be plugged into a console ...
Hello. I've connected to the router via the console port (I've also tried the AUX port). And I can't get an image to upload. I keep getting this error message:BP-INET1#copy xmodem flash:Destination filename []? c2600-i-mz.122-17a.binErase flash: be...
Okay - we have a bandwidth issue and I just wanted to see what you think some good options are. Quick run down of the setup:We have 200 employees at our main office. This is growing at a rate of 40 per year for the last few years. I was employee...
We have the same problem. In our case, we are trying to assign a 10.203 address to the VPN clients. However, ACS is giving out a /8 subnet mask. This is a problem because it will think the entire 10.0.0.0 address space is local - not to mention ot...
Yes. But I'm trying to upload it without bringing the router down. So I'm trying to upload via console cable while the router is live. Then I can schedule a reboot for off-hours.
Oh - and my flash is alrady erased. I've also tried it both ways saying to erase or not erase my flash (which is already gone). And it's on-board flash not a card.
I guess I found my own answer. At least AN answer. I am sending level 6 logging to our syslog server. Seems like a lot of message to log, but I couldn't think of another way to do it. Is there another way?
Well, I went the more restrive route in that I only allow certain ports such as WWW and FTP to exit our network. I would think that would effectively shut down Kazaa use because I don't think it will assign port 80 or 21 for traffic. Besides, if it...
