Hello.I'm having an issue with SSH console slowness once connected into a network device on GNS3. It generally slow on any router/switch regardless of the configuration to ssh/vty lines.If using Telnet it's perfectly fine and very responsive but ssh ...
Hello.Got a simple STP instance with 3 L2 switches in GNS3.Just Spanning tree priorities and VLAN 1 interfaces are configured: SW-01#sh run | i spanningspanning-tree mode rapid-pvstspanning-tree extend system-idspanning-tree vlan 1 priority 4096 SW-0...
Hello.
Routers R1 and R3 are in the same AS. They are running OSPF between physical interfaces and iBGP over loopbacks on top of OSPF. R1 receives all of the routes from KCOM and has them in its routing table. R1 advertises these routes to R3 via iB...
I was able to configure a Cisco router to be a DNS server but is there a way to get a reverse DNS configured on it? When pinging the router's IP address it should resolve the IP into a hostname.
I was able to configure a Cisco router to be a DNS server but is there a way to get a reverse DNS configured on it? When pinging the router's IP address it should resolve the IP into a hostname.
Hi.I'm using the below images:i86bi-linux-l3-adventerprisek9-15.4.1T.bini86bi-linux-l3-adventerprisek9-ms.155-2.T.binBut even the L2 images have the same issue. Thanks.
@luis_cordova, @Martin L Thanks for your replies guys.The trunking encapsulation I use is dot1q. I'm using SVIs for pinging and telnet purposes.Changed the VLAN to VLAN 10 and I'm not getting endless ARP Broadcasts any more. Pinging works as normal a...
I am able to resolve ip addresses into names with the ''ip host'' command but I need it the other way around. Say if you were pinging an IP address it would show you the host name of it.
