When I use the console port I will sometimes get normal characters but most of the time it just oupts junks. The console port is default speed at 9600 and terminal session is set right. I have 40 switches and this is the only one giving me an issues....

I have one primary and one secondary OC3 at my hub along with full T1's and DS3 connections at my remote sites. At my hub site I currently have two 6509’s with pos cards in them running a sup-720. I currently have 83 PVC's hanging off my one OC3 inte...

I have either a 5505 or 5509 series switch and I want to install a L1010-ASP-B-FC1ATM SWITCH/PROCESSOR-B along with a Cisco WATM-CAM-2P Lightstream ls1010 module. The documentation I found was they can go in a 5500 series switch but one says 5513 and...

I am converting from a sup2 Native IOS to a sup720 IOS and I can't seem to get these command to work. I can an error mesage VLAN 1 TLB 1 VLAN 1002 has inconsistent TLB values (0 / 0). The command is for each of the vlans.Vlan 1 vlan 1002 tb...

I have a pix 520 handing out my dchp address in a small remote office due to that they use a cable modem for access to the internet and the dns servers change regularly. If I have no encryption turned on then the laptop associates fine with the AP an...