Hello all!I have a Ubiquiti ER-4 in my hub office, that I am trying to connect to an ASA 5515 VPN in the datacenter. I have match the pre-shared keys and gone through the Config Wizard (https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-s...
Hello All, I have one UCS B200 M3 blade with a predictive HDD failure. <faultInst
ack="no"
cause="equipment-degraded"
changeSet=""
code="F0996"
created="2019-04-27T00:50:10Z"
descr="Local disk 1 on server 2/6 operability: degraded. Reason: Driv...
Hi All, I have a Cisco ASA 5515-X in a datacenter that is configured and working well for 7 other VPNs (mostly L2L and one client VPN), and a remote office that has an ISR-2921 that has an established VPN IPsec tunnel to the ASA-5515-X but they can't...
Greetings, I have two Cisco Catalyst 2960-X in a stack, and a ISR 2921attached to a switch on the corporate network on a port that gives direct access to the internet. They are cabled in the following manner: Direct access to internet via corporate ...
I tried this as well: https://help.ubnt.com/hc/en-us/articles/115011058387-EdgeRouter-Site-to-Site-IPsec-VPN-to-Cisco-ASA For those commands I have already in the running config:1. Enter configuration mode.2. Define Network Objects for the remote and...
Hi! Thanks for the help, I tried your helpful tip but I didn't find any instances of the peer's IP (aside from my command that I typed in) in 13,030 lines that I saved to a text file.
Hi,There are many VPNs on this ASA."sh crypto isakmp sa" and "sh crypto ipsec sa" don't show either end points' IP.The control panel for the EdgeRouter 4 in "VPN Status" simply says AES256 and "down"Thank you!
What I did was enter the command: crypto ipsec transform-set ASA-IPSEC esp-aes 256 esp-sha-hmacThat affected the previous sh run output from:!crypto ipsec transform-set ASA-IPSEC esp-des esp-sha-hmac mode tunnel!Changing it to the current config: !c...
Hi Georg Pauwen and Richard Burts,
Thank you very much for your time and help. That worked! The tunnel is fully working now and I can ping/ssh/navigate to all of our internal resources as if I were on the network exactly as I expected!
One thing...
