I am tring to use PBR on 3750, some reson it doesn't take on the running config. I am using 3750 as L3 switch with sdm desktop template enabled. I am trying to configure it on a L3 interface.Both a.b.c.0 and x.y.z.2 are directly connected.route map c...
Is there any way to block traffic on a BVI interface using IP (not mac or any layer 2 method). I am using a 2948G-L3 (which i believe is a special case) with bridge irb. I have a 2950 connected to it using etherchannel and all access layer switches a...
I am having 6 2950T-48-SI switches. These switches have 2 1000BaseT ports instead of GBIC slots. Will I be able to stack them like other 2950s. If so , how?Regards,Tijo
I have set up a 7940 with windows sip proxy. In this is I am able to make outgoing calls, but unable to receive any incomming calls. The caller gets the ring on their end, but it does not ring on my end.Looking forward to your suggestions.-Tijo
I have upgarded a 7940 with SIP 7940 Release 6.0 package. However i get a message"Phone Unprovisioned" on the phone. In status messages i get "W210 tftp error: timeout SIPDefault.cnf". what is more weird is the fact that even though i get same error ...
I will have 2 3750G-24T-E switches for redundency as a collapsed core-distribution layer. They will be cross connected for redundency. Each access layer switch will have 2 uplinks - one to each 3750. Also I will have other unmanaged d-link switches c...
I am using Microsoft SIP proxy for making calls. Also i am not having 1 way switching. The problem i am having is that i am able to make outgoing calls, however when someone calls me, they get a ring tone, but the 7940 ip phone doesn't actually ring....
