Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm going to setup an active/standbye cluster using ASA 5510's, but i've a problem so one of the ASA's hardware model is ASA5510-K8 while the other one's just ASA5510.Actually they are same as hardware but only difference is K8 according to ...
Hi there,We're trying to implement isdm2 as inline mode integrated with fwsm module. We have two vlans on the switch: vlan 30 is responsible to take care the outside interface of the lab context of fwsm while vlan 40 is responsible from the inside in...
hi,we've a 6509 with the ios version 12.2(18)SXD5. Even if i don't enable netflow per interface , i could see a lot of traffic pass the router with the command " show ip cache flow"And the output is the same when i try for example "show ip cache flo...
Hi all,I need to define incoming and outgoing calls per e1 separately under AS5400HPX platform using related mibs. But i could not find anything in the mib locator about that.Is there anybody who did succeed in this job before ?Thanks in advance.
no idea? While i was looking for the solution, i have found mpls TE fast reroute feauture. But i am not sure whether it solves my problem or not...thanks in advance mali
hi paltel;Unless your ISP does provide your net with same QoS settings , you are not able to control your downstream traffic. Because of the administration of the router on your side belongs to you, you can control only outgoing traffic.For the ingoi...
hi alex;the configuration you have done would be valid only for the upstream traffic from your side to the isp. to control downstream traffic your, ISP should configure their router according to the different nets on your side.This is the only soluti...
