Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have implemented a new ASA 5506 running 9.9. I have these interfaces:
*interface outside-ip address by dhcp and its the default route, security=0
*interface inside 1-ip network vlan1 10.0.0.0/24, security=100
*sub interface inside 1.2-ip network...
I want to change the name and location of AP's that are connected to my 3650 wireless control module. I have found a post that list these commands as:
config ap name
Then you can also add the location value of the ap:
config ap location
Howe...
When i look at my switch model on the Cisco IOS downloads page, there is a letter on the end of the IOS. When i do "show version" on my switch it does not have that last letter. Im looking for that information please. (-E -L -S)
Catalyst 3650-12X...
I have a 3650 switch running 16.3.5b. If I wanted the config from a WAP that was connected to that switch and using its integrated wireless control module, how would I do that? Can i telnet/SSH into the IP? Or is there another way from the IOS of ...
I have 2 switches with a trunk between them (both ports set to <sw mode trunk>, <sw nonnegotiate>). One is a 3650 and the other is a 2960.
The 3650 is in VTP server mode
The 2960 is in VTP client mode (both ver 1)
Pruning is enabled on both switch...
I have things figured out.
In using the ASA to connect to multiple networks via the interfaces, asymmetric routing was happening. Traffic was passing through the interfaces and were keeping its original ip addresses and ports on the cross network....
Im writing this post for clarification. In my 1st post I simplified the issue and in my config you will see that I have 3 subinterfaces on Gi1/2 (10.2.6.0/24 vlan01)
2.4 10.2.4.0/24 vlan04
2.5 10.2.5.0/24 vlan05
2.11 10.2.140.0 vlan11
From Gi1...
To change the name or location of the AP these are the commands:
AP info-
show AP config general
or
Show AP name <ap name > config general
To change the name or location setting-
in enable mode (not global config):
ap <name> [perameter] (in...
