Dear Cisco TeamCould you please clarify if the following port adapter in 7200 / 7500 can support E1 G.703 ( Unframed ) Configuration like PA-4E1G/120 without configuring ATM parametersPA-A3-8E1IMA Eight-port E1 ATM port adapter with IMA Thanking...

I m trying to configure ASA 5540 in transparent firewall mode. The server farm is connected to the inside zone and users are connected to the outside zone on Multiple VLANS routed via Inter-VLAN routing using core switch.As per Cisco Configuration gu...

ONT 1031 is not being deducted by the ESSE when connected thru' a catalyst 3550 switch. Question 1 :Is L2NMP protocol required for the management of ONT 1031 by ESSE supported by the Catalyst 3500 / 2950 series switches Question 2:Is there any IOS up...

I have a requirement of providing Internet access to INSIDE users based on groups using a PIX firewall with multiple Zones connecting to 3 Internet uplinks ( different modes like 1 Leased Line, 1 ADSL & 1 ISDN ) as shown in the enclosed slide. Can so...

I have been facing problem with Catalyst 3548XL & 2950T switches as they report wrong port numbers ( id's ) when polled by an Linux server using snmpwalk command.There are 14 x 3548XL switches connected on Gigabit dot1Q trunk to 3 x 6 port GBIC modul...