Hi....I am new to QoS and need help on configuring the same for 7206 VXR.My test topology is as follows :The Emulated router is configured using IXIA traffic generator using the GUI with one port sending the marked and classified traffic and the othe...
Hi Friends...I am struggling with this type of ethernet interface on 3640 as I need it to support 100 Mb whereas I read somewhere on net that this type of hardware "AMD Presidio2" won't support 100 Mb. Max this type on interface would support is 10 M...
Can someone please let me know the power consumptions of FULLY LOADED 7301,7606,7609,catalyst 6513 and GSR 12,410????I'm unable to gather the information.Regards,MITHIL
Hi Friends, I have done my CCNA 2.0 which expired in January 2004 before which I appeared for BSCI 642-801 in Jan.2004 itself and passed it successfully. So eventually my CCNA certification got extended. Right now I am preparing for CCIP. CCIP consis...
HI Martin...Thanks for ur reply. It helped me a lot. But even after doing the configuration, I faced some strange problem. The VXR behaved very strange for the load (emulated traffic) from IXIA for different frame sizes. The VXR was passing only the ...
Raj,Locate where does ur image reside. Do a dir /all.Considering it in disk2:,boot the VXR into rommon mode and do this ..rommon> alias boot="boot disk2: " rommon> sync rommon> reset If the desired Cisco IOS software image is not the first image on t...
Hi Raj...As pointed by Prem and Leon, lookout the exact part number and trace the same on :http://www.cisco.com/pcgi-bin/finder/msbsearch.plHope this helps...Mithil
Hi Peter,The CE connectivity can be done by using normal VLAN tagging. Normally, when u talk of VPLS, the PEs are fully meshed and the corrsponding port of the CE side on the PE is "xconnected" to the particular Virtual forwarding instance (VFI). Ref...