Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am attempting to replace antiquated hardware in my CM cluster and wanted to run the procedure by the forum to make sure I am on the right path.I have a two-node cluster (CM1 as pub and CM2 as sub running CM 4.1(3)) and have a new MCS-7835 to ...
Hello,I am currently upgrading all my Unity servers from 4.0(2) and 4.0(3) to 4.0(5). I have configured my CallManager 4.1(3) systems to do a direct transfer to a subscriber's greeting using the following document:http://www.cisco.com/en/US/products...
Hello,Is there planned support for FTP access via WebVPN besides doing port forwarding? There should be an FTP selection in the 'WebVPN Servers and URLs' section to enable placing an FTP link on the default page (e.g. ftp://<hostname>).Thank you in ...
Hello,I am using CallManager 3.3.3sr4a with the 7920 wireless phones and Cisco Aironet 1200 APs. When I select Corporate Directory from the Directory menu, I receive a 'request failed' error. I receive the same result when I select Services. I not...
Does anyone have any information/documents on how to get EAP-GTC authentication against a Novell eDirectory database? The ACS docs do not mention that LDAP is required to get this working, just the Novell Client, but several posts here state that a ...
Thanks so much for the quick response.I placed option 78 in my pool for IP addresses for 172.16.2.13 and 172.16.2.14 as follows:option 78 hex ac10.020d.ac10.020e, but is still not working. The following Novell TID explains that the 'Length value mus...
Thanks for the quick response, Chris.Attached find the Call Viewer logs. As you can see, the upgraded server shows the call type as 'Direct' whereas the functioning server shows the call type as 'Fwd (unconditional), which would use different call r...
If you are authenticating against Novell eDirectory/NDS, you should use EAP-GTC. Also, when you create your database configuration, be sure to enter all contexts (separated by commas) in which your user accounts reside.
Hello,I know this post is rather old, but I, too, am trying to get Citrix Metaframe working with a 3030 concentrator. I have port forwarding setup for TCP 1494 and 3389 (terminal services) as well with the "Enable Citrix Metaframe" box selected. Ar...
